PR160 Rig w/ Fan Kit
- PR160 Rig w/ Fan Kit
The PR160 Rig with Fan Kit is a specifically designed mounting system for typical laboratory photocatalytic reactions. It's full adjustability and secure mounting provides consistency, accuracy, and repeatability. The Kit also comes with a powerful fan to blow air from the top efficiently (proved to be more efficient than clamp desktop fan) to keep the reactions at room temperature as much as possible. It also comes with light-blocking shields for lab safety, which blocks all UV light and most blue light.
Note 1: The kit does not come with the base.
Note 2: Stir plate can be used. The PR160 Rig w/ Fan Kit is attached to your typical lab supporting bar (monkey bars) - "hanging in the air" above the stir plate
These Intensity Maps are very helpful to determine lamp distance and intensity output. Hard copies are included in the PR160L light package and can be placed under the vials. Multiple vials can be aligned in the same contour line of the same intensity for even light distribution
Attach the Center Mount (G) to a vertical or horizontal supporting bar and secure it with a 20mm Thumb Screw (J). The Center Mount (G) can attach to supporting bars ranged from ø12mm to ø20mm.
Thread the 15.75 inches (400mm) Center Rod (E) through the hole on the Center Mount (G) and secure it with a 15mm Thumb Screw ( I ).
Attach the Side Mount (H) to the Center Rod (E) and secure it with a 15mm Thumb Screw ( I ).
Thread the Side Rod (F) to the Side Mount (H) and secure it with a 15mm Thumb Screw ( I ).
Secure the Back Arm (L) to the back of the light body with two M3 screws (K).
Attach the Back Arm (L) with the light body to the Side Rod (F) and secure it by turning the knob.
Use Cable Ties (C) to combine Light-blocking Shield + Fan (A) and Front Light-blocking Shield (B) , and tighten up Cable Ties (C).
Place Light-blocking Shield + Fan (A) and Front Light-blocking Shield (B) on top of the rig.
Attach the Y-split Cable for Fan (D) to the fan and the light. Connect the other connector to the power supply.
What's in the Box
A 12.6 x 9.06 inches (320 x 230mm) Light-blocking Shield + Fan
B 12.6 x 4.72 inches (320 x 120mm) Front Light-blocking Shield
C 5.91 inches (150mm) Black Cable Ties (x4)
D Y-split Cable for Fan
E 15.75 inches (400mm) Center Rod
F 10.63 inches (270mm) Side Rod (x2)
G Center Mount
H Side Mount (x2)
I ¼"-20, 15mm Thumb Screw (x5)
J ¼"-20, 20mm Thumb Screw (Only for G)
K Screw M3 x 5mm Pan Head x 10 (Backup screws for PR160)
L Back Arm (x4)